Filter
Top Products
40672201TX Rev.4
4 - 111
4-4-3 AUTO REC Key Operation (When MEM.PASSWORD is registered.)
Fig. 4-4-3-3/3 AUTO REC Key Operation (When MEM.PASSWORD is registered.)
14:14 FAX
Press AUTO REC. key.
14:14 FAX
AUTO RECEIVE MODE
Press AUTO REC. key.
Press AUTO REC. key.
TEL/FAX ON
TEL/FAX OFF
End of programming + 1 second
(Flash memory writing)
*1) When call incoming mode is set to MEM (memory), and PRG.PASSWORD is registered.
*2) When call incoming mode is set to the mode except MEM, or when call incoming mode is
set to MEM and PRG.PASSWORD is not registered yet.
*3) When memory reception data exists in the memory, refer to the flow chart of the attached sheet 2.
No change AUTO REC. key
operation
Press AUTO REC. key.
TAD MODE ON
TAD MODE OFF
Press AUTO REC. key.
Press AUTO REC. key.
1234
PASSWORD OK
PASSWORD NG
←
key
∗2
∗1
key
→
Memory near end
Operating as MFP terminal
Operates as FAX terminal
14:14 TEL
Press AUTO REC. key.
14:14 TEL
MANUAL RECEIVE MODE
After 3 seconds
elapsed
14:14 T/F
Press AUTO REC. key.
14:14 T/F
TEL/FAX AUTO SW MODE
14:14 TAD
Press AUTO REC. key.
14:14 TAD
TAD/FAX AUTO SW MODE
14:14 MEM
Press AUTO REC. key.
14:14 MEM
MEMORY RX MODE
PRG. PASSWORD [_ ]
ENTER 4DIGITS
PRG. PASSWORD [1234]
YES(
←
) NO(
→
)
PASSWORD ERROR
14:14 PC
Press AUTO REC. key.
14:14 PC
PC MODE
*1
PROGRAMMING
Go to Stand by mode.
1
After 3 seconds
elapsed
1
After 3 seconds
elapsed
1
After 3 seconds
elapsed
1
2
After 3 seconds elapsed
1
2
After 3 seconds
elapsed
After 3 seconds
elapsed
1
Press AUTO REC. key.