Filter
Top Products
40672201TX Rev.4
4 - 5
4.2.4 COPY
Function: This key is used for four purposes: document copying, transmission or commu-
nication receipt output, location programming for one-touch or autodial and
service person setting mode.
When document is placed on ADF, the switch serves as a command key to
direct the machine to start a copying operation.
Pressing this key without any document on the feeder causes displaying the
latest transmission result on LCD and pressing this key again within 3 seconds
causes the latest transmission receipt. (Refer to Fig. 4-4-2.)
Pressing this key allows the operator to location programming for one-toch or
auto dial before start of dialing at the end of entering telephone number by ten
key. (Refer to Fig.4-4-21-2/2 )
To set the service person setting mode, either press the FUNCTION key first
and press the COPY key twice or turn on the power supply on while the COPY
key is being held down.
Display: When a copying operation is initiated, a message to indicate the copying status
of the machine will show up on LCD display. Upon completion of the copying,
LCD display will return to the indication of stand by (current time).
During printing Message Confirmation, a message to indicate the machine status
will show up to LCD display. Upon completion of the printing, the message will
change to stand by (current time).
4.2.5 Select Function
Function: This key is used for triggering selection of various functions. LCD display will
return to standby mode immediately, when pressing this key during selection of
various functions.
Display: The following message is displayed on the LCD upon pressing this key whether
document is placed on the ADF or not.
SELECT FUNCTION (OT)
MEMORY AVAIL = 100%
The upper line message indicate to press that One touch key to which a desired
function is assigned.
The lower line message indicates the available memory as a percentage (%).