Filter
Top Products
40672201TX Rev.4
4 - 53
4.8.7 Hyper power save mode (This wording is tentative)
To decrease the machine's power consumption, machine supplies power only for Control
Panel circuit and a part of NCU board circuit in standby mode.
Refer to Fig.4-4-20
Machine shows *POWER SAVE MODE PRESS "START" during power save mode.
Main power turned on conditions:
1) When Power switch is turned on.
2) When Start key is pressed on standby condition (all other key operations are ignored
without key touch tone)
3) When ring signal from out side line is detected.
4) When Off Hook (hand set) is detected.
5) When PC1 (Document) is detected for TX or COPY.
Main power turn OFF conditions:
Main power is turned off automatically when the main power off timer (180 seconds)
is activated and after which machine becomes real standby mode.
Real standby mode does not allow following conditions:
1) When power save mode setting is OFF by user.
2) When operation is activated such as FAX TX/RX, local copy, report printing, during key
operation, PC interface mode, warming up, maintenance mode.
3) Hook up condition
4) Alarm condition
5) When image data is stored in memory (memory reception, confidential reception,
memory transmission)
6) Delayed TX mode or waiting for redial
7) When manual recording paper feed is detected.
Refer to Fig. 4-4-20.
4.8.8 V34 (33.6/22.8KBPS) MODEM
V34 MODEM is not available.
4.8.9 FAX forwarding
This function is not available.
4.8.10 Cleaning Page mode
To remove residual impurities from printing surfaces or to reduce problems such as repeating
marks, blotching, and shading.
Operation: