Filter
Top Products
40672201TX Rev.4
B-13
5.2 E-mail Address
The figure below shows a procedure when the sending destination is an E-mail address.
FAX2NET server
- TA < 10 sec.; TB < 6 sec. TC < T0 timer set value. At TA or TB timeout, the service code is
14D0.
- The length of each DTMF tone is 300 ± 25ms. The time between digits is 100ms min. and 5
sec. max.
- The Account number, destination facsimile number, and check sum are delimited by DTMF
tone “*.”
- The system adds DTMF tone “#8901” before the E-mail address and assumes that a DTMF
tone group succeeding “#8901” is obtained by converting an E-mail address
- For details on check sum, see Section 5.5.
- When the FAX2NET server issues digit “D” instead of digit “B,” the request is rejected. In
this case, disconnect the line smoothly.
- After digit “B,” CNG need not be issued from the facsimile.
FX051
Digit ‘A’
FAX2NET server
DIAL
Digit ‘B’
CED/NSF/CSI/DIS
Account number +‘*’
Destination E-mail address +‘*’
Checksum +‘*’
Digit ‘#8901’ +‘*’
TA
TB
TC
T.30 protocol