Filter
Top Products
40672201TX Rev.4
4 - 32
17: Memory TX/Feeder TX switch
Function: To select the transmission mode (MEM. TX/FEED. TX) of default.
This function becomes effective when Instant Dial of No. 26 is set to OFF.
(Refer to P.4-20 Document reading timing)
Operation: Refer to Fig. 4-3-18.
18: Default arrangement for power save mode (ON/OFF)
Function: To enable or disable the power save.
Operation: The operation for setting of default position is described in Figure 4-3-17,
Fig. 4-3-18 and Table 4-6.
Note: No setting for ODA version
19: Default arrangement for ECM function (ON/OFF)
Function: To enable or disable the ECM function.
Operation: The operation for setting of default position is described in Figure 4-3-17,
Fig.4-3-18 and Table 4-6.
20: Default arrangement for remote diagnosis (ON/OFF)
Function: To enable or disable the access to this machine from the remote center
for diagnosis.
Operation: The operation for setting of default position is described in Fig. 4-3-17 and
Fig. 4-3-18.
21: Default arrangement for PC/FAX switch (ON/OFF)
Function: To enable or disable PC interface function.
When PC reception is not available, for example, application is not
activated on the PC or cable is missing between PC and fax etc., this
setting allows to switch from PC to fax reception automatically.
ON: Automatically change to fax reception
OFF: No reception
Operation: The operation for setting of default position is described in Fig. 4-3-17 and
Fig. 4-3-18.
22: No toner MEM RX
Changing from service function setting to user function setting.