Filter
Top Products
40672201TX Rev.4
4 - 17
Pressing the START key will cause the machine to seize the line and start
dialing to the exchange. Fig. 4-4-6 shows AUTO START ON in parenthe-
ses, which denotes that there is the case in which the operator does not
need to press the START key when "AUTO START" is enabled.
The message corresponds to " " shown in Figure 4-4-6.
OKI TAKASAKI
DIALING
The dialed digits is shown into the top message line of the LCD as:
0273 56 7890
DIALING
When the machine has completed dialing, the message on the LCD will be
changed to:
0273 56 7890
CALLING
The machine proceeds to send the message which is identified by the
"ONE-TOUCH" block shown in Fig. 4-1-1.
Assuming the call is answered, the operator may hear the CED tone re-
turned from the distant station through the built-in speaker.
Auto-Dial Code Dialing
Assuming the handset on hook, the operator first taps AUTO DIAL key. The
machine responds to the command and displays the following message on
the LCD:
AUTO DIAL NO. ?[_ ]
ENTER 01-70
As an assumption, the desired telephone number has been assigned to
AUTO DIAL 01. Then, the operator taps "01" and the message will be on
the LCD:
OKI HONJYOU
YES(START) NO(LOC.)
The message corresponds to " " shown in Fig. 4-4-6 because "AUTO
START" is disabled and the call is originated on hook. The operator taps
the START key.