Filter
Top Products
40672201TX Rev.4
4 - 12
4.3.1 Power Turning On
It is assumed that the machine is unpacked and installed on a desk or appropriate stand.
All default conditions (the machine configuration parameters) are assumed as those set at
the factory, including AUTO RECEIVE MODE which is set to ON.
a) Connect the socket end of the furnished power cord to the AC Inlet, and the other
end to the wall outlet.
b) Turn Power Switch on.
Refer to Fig.4-4-20.
1) Initial reset is executed within several seconds.
2) AUTO RECEIVE will be displayed on the LCD that the machine is ready for
automatic message reception by NO PAPER RECEIVE even before print paper
is loaded.
3) Machine goes to Power Save Mode when machine detects power save condi-
tion.
Machine shows POWER SAVE MODE PRESS "START" when machine move
to power save mode.
Note: POWER SAVE MODE is not available for ODA version.
ALARM (LED) turned on indicates that the machine needs paper loading.
The machine is ready for automatic message reception into memory, - however, due to the
memory capacity limited, it is not recommendable to leave the machine with no paper for
prolonged time. Load print paper by using the tray as soon as possible.
4.3.2 Paper Loading
Set the recording paper into the paper loader(Tray paper) and press STOP key.
The ALARM indicator will be automatically turned off, and the message on LCD display will
change to Current Time, indicating that the machine is now in the normal standby state
(Auto Receive Mode set to ON).
Note: Paper size must be set by user key operation because the machine cannot detect
the paper size automatically.
4.3.3 Typical Transmission
The step by step operation for typical message transmission in G3 mode will be discussed
with reference to the following figures:
Fig. 4-1-1 "Typical Message Transmission"
Fig. 4-4-6 "Calling Operation"