Filter
Top Products
40672201TX Rev.4
4 - 14
6) Pressing the SEARCH key causes searching of the registered destinations
(from among one-touch dial No. to 2-digits auto dial code). There are two
following cases in this mode:
• Manual search dial (the fifth flow from the bottom in Fig. 4-4-6)
• Auto search dial (the fourth flow from the bottom in Fig. 4-4-6)
In method 1), the operator uses the local keypad of the machine to dial select
the distant station. The machine can monitor the dialed number and store it in
memory temporarily. This information allows the operator to use REDIAL for
manual redial and/or Auto Redial when the call encounters "line busy" or "no
answer."
In method 4), the operator dial selects the distant station and completes connec-
tion to the distant facsimile facility through the use of the dialing facility of the
external telephone unit. This type of dialing is called "Manual Dialing." No dial
information is stored in the machine, and the features such as "Manual Redial"
and "Auto Redial" are not available for this type of dialing.
In any of the method 1), 2), 4), 5) and 6), the machine stores the address
information in memory. Therefore, the machine can use them for redial pur-
poses. For example, "Manual Redial," and "Automatic Redial," "Broadcast
Transmission," etc.
a) Loading Document Pages on ADF (Automatic Document Feeder)
When the machine is in standby, LCD will continuously display the current
time information on the top line, indicating the standby state of the machine
as:
14:59 T/F
This message corresponds to "1" of Fig. 4-4-6 (Calling Operation)
Open the DOCUMENT GUIDES to the width just enough to accept the
document, and load all five document sheets on the ADF facing down and
the top edge leading aligned into the slit of the ADF. Preliminary feeding
occurs when the documents are set.
On the Control Panel, STD for TRANSMIT RESOLUTION and NORMAL for
TYPE OF ORIGINAL should glow amber, indicating the document scanning
resolution and contrast compensation for use. If the operator wishes to
change the parameters, he/she can do so by tapping the corresponding
YES and/or No.