Filter
Top Products
40672201TX Rev.4
4 - 33
Function: To enable or disable MEM RX when toner low condition.
ON: To receive the message in the memory when the remaining toner
level is low or none.
OFF: To print the message even the remaining toner level is low or
none.
23: MEM full save
Function: Broadcast transmission and other features originate calls after all the
documents read in the memory. When Memory Full occurs during
reading documents and operator time out occur, all the readout data must
be deleted (OFF setting) or all the data must be sent. (ON setting)
Select either ON or OFF setting as follows:
ON: Selecting display
OFF: Selecting delete at all times
Operation: To operation for setting of default position is OFF in Fig. 4-3-18.
24: Continuous tone
Function: Setting of sounding warning tone after reception.
ON: Warning tone sounding stops by operator's STOP key pressing
OFF: No warning tone
Operation: To operation for setting of default position is OFF in Fig. 4-3-18.
25: Instant dialing
Function: Setting to start reading documents upon call origination when transmitting.
Refer to attached table "Document Reading Timing". (Page 4-20)
Operation: The operation for setting of default position is enable in Fig. 4-3-18.
26: Restrict Access
Function: To enable or disable restrict access function.
Restrict ID registration (Fig. 4-3-24) becomes effective when Restrict
Access is set to ON.
Operation: The operation for setting of default position is disable in Fig. 4-3-18.
27: Width Reduction
Function: Performs the reduction of the horizontal scanning. (However, only when
printing of Copy/reception message.)
See section 4.7.2.1 Variable (reduction) printing.
Operation: The operation for setting of default position is desable in Fig. 4-3-18.