Filter
Top Products
40672201TX Rev.4
4 - 23
sion, confidential transmission, relayed initiate transmission, feeder polling transmission,
and transmission preparation) are described in Section 4.3.
Refer to Fig. 4-1 (1/2 - 2/2 General Key Operation).
4.4.1 Method for Selection Function
Press the FUNCTION key once to enter the mode for selecting the user functions.
Pressing the FUNCTION key again, after setting either mode, cancels the operation. In the
setting mode, the operator can turn the menu level back to the previous selection by
pressing the STOP key.
a) Selection method
Detailed branching for communication operation or file management shall all be done
according to the guide message on the LCD. The keys (for input) allowed to be
selected by the user shall exist on the panel or LCD screen. The selection method is
roughly classified into the two types as follows:
1) YES/NO selection
YES and NO are assigned to arrow keys ← and →. To affirm the data on the
LCD, press the YES (←) key. Each time the NO (→) key is pressed, new alterna-
tive data for selection is displayed on the LCD. This method is always available for
the user, except for the serviceman data.
OFF
ON
ON/OFF SELECTION
NO ( )
NO ( )
2) Multiple number designation
When there are multiple branches, it is possible to select the number (selecting
value) arbitrarily given by the system by pressing the arrow key at the right (NO)
and set it by pressing the arrow key at the left (YES).
123
1/3/3 SELECT
NO ( )
NO ( )
NO ( )