Filter
Top Products
40672201TX Rev.4
4 - 40
18. Error Criterion (00-99)
To select the error criterion ratio. Refer to 4.8.13.
19. Off-Hook Bypass (ON/OFF)
Switching the function of maintaining communication without hooking up the telephone
set in usual test, etc.
20. Non-Loaded (NL) Equalizer (0, 1.8, 3.6, 7.2km)
Determining the equalizing level of the receiving signal.
0, 1.8, 3.6 and 7.2km are selectable.
Definition: Equalizing level is the difference of gain of equalized signal between 0.3
kHz and 3.4 kHz.
21. Attenuator (0 to 15 dB)
Adjusting the attenuation (dB) for the send signal power level.
22. T/F Tone Attenuator ( 0 to 15 dB)
Adjusting the attenuation (dB) for the tone send signal for TEL/FAX switching.
23. MF Tone Attenuator (0 to 15 dB)
Adjusting the attenuation (dB) for the MF tone send signal power level.
24. Ring Duration Detection Time (100 MS - 990 MS)
Selection of minimum ring detection time according to each country's requirement.
The time is selectable between 100 MS and 990 MS by 10 MS step.
25. CML Timing (100 MS - 1900 MS)
Selection of the time from end of the ring to CML-ON.
The time is selectable between 100 MS and 1900 MS in 100 MS step.
26. LED Head Strobe (00000 - 11111)
Selection of strobe width in LED head.
"00000" is lightest and "11111" is darkest.
27. LED Head Width
To switch the type of LED head whose width is TYPE1 (2496 bit) or TYPE2 (2560 bit).
28. MEDIA TYPE (M/MH/H)
The recording paper quality is selectable among Medium, Medium-heavy and Heavy.
29. TR Latch Current (-2/-1/0/+1/+2)
To select the latch current for transfer roller.