Filter
Top Products
40672201TX Rev.4
4 - 21
If the machine receives no CSI and no NSF from the distant station, the
message on LCD display will be:
OKI-TOKYO
SENDING /144
OKI-TOKYO is calling ID which is
registered in One touch key.
e) Transmission Starts
After setting the document pages and storing the image data in the memory,
the machine begins the handshaking with the distant station. If the 14400 bps
training is successfully completed, then the machine will start transmitting the
image data in digitally coded form. If the training fails due to the line condition,
an automatic fallback to a lower rate will occur. The result will be indicated on
MCF REPORT.
f) Transmission Ends
When all of the document pages are transmitted successfully, the machine
will automatically display the following message:
RESULT=OK
In either case mentioned above, the message on the LCD will return to time
in about 5 seconds, indicating that the machine is again in standby state.
4.3.4 Other Transmission Function (Fig. 4-3-1)
This machine is provided with other transmission functions listed below.
• Delayed TX (Fig. 4-3-7)
• Confidential TX Programming (Fig. 4-3-9)
• Relayed Broadcast initiate (Fig. 4-3-10)
• Polling TX/RX Programming (Fig. 4-3-11)
• TX preparation (Fig. 4-4-16)
If a TX preparation request is made when memory full during reception or data transmission
from memory, the machine sends the documents on the feeder at the completion of the
current send or receive operation. In the operation of TX preparation the document is pre-
feed.
This feature is available for the confidential message TX, relayed broadcast initiate, and
memory transmission.
SENDING /144
Calling ID does not registered
in One touch key.