Filter
Top Products
40672201TX Rev.4
4 - 51
4.7.4 Heater control
The temperature of the toner fixing heater is lowered in the standby state to reduce power
consumption and heat generation. The heater control operation is shown below.
• The printer is normally placed in the standby.
If a call is received in this state, the heater is started; however, it takes a typically of 20
seconds for start printing. (This does not make longer the transmission time for document
images such as ITU No. 1 sample document because, when a call is received the heater
turned to ON, and printing of the first page starts after the preliminary procedure is per-
formed and received image data.)
4.7.5 Warming up of the printer
The printer starts the warm-up sequence to warm the toner fixing heater immediately after the
power is turned on.
4.8 Other Functions
4.8.1 Language
Selection of 2 languages shown on LCD and printed on reports is available to the user.
Language selection is available for destination.
Default : Refer to Table 4-6.
1st
page printing
Heater start *
Printing start
Heater warming time
(seconds typ.)
Approx. seconds
1st page ejection
The preliminary procedure is performed and image data for the
first page is received in this period.
* The heater is started by call reception.