Filter
Top Products
40672201TX Rev.4
4 - 35
a) Redial time (0 to 10 times: one time steps)
b) Redial interval (1 to 6 minutes: one minute steps)
c) Dial tone detection (ON/OFF)
d) Busy tone detection (ON/OFF)
e) MF or DP (MF/DP)
f) DP rate (10/16/20 pps)
g) DP make ratio (33%/39%)
h) DP dial type (N/10-N/N+1)
i) MF duration (75/85/100 ms)
j) PBX Line (ON/OFF)
k) Flash/Earth/Normal (R/E/N)
l) Auto start (ON/OFF)
m) Dial prefix (0. 1. ... 9)
n) IT2 detect (ON/OFF))
AUTO START: If the AUTO START is turned ON, dial operation is
automatically started immediately.
If the AUTO START is turned OFF, dial operation is
started when the START key is pressed. If the START
key is not pressed within 60 sec., the machine is initial-
ized.
4.4.7.6 Personal box programming
To allow operator to assigne a two functions to 8 personal-box.
(a) Confidential RX
(b) Bulletin Polling TX
Function: Used with confidential RX and Bulletin Polling TX and Advanced T30 protocol.
Personal box setting for Bulletin poll using SEP frame and Confidential using
SUB frame when remote machine have a SEP/SUB capability.
Operation: The programming operations are described in Fig. 4-3-1 and Fig. 4-3-22. The
box No. 0 is used for only grobal Bulletin Polling TX.
4.4.7.7 Memory password programming
Function: Registering the password required (4-digit numerals) for outputting the data
received by Memory Only Reception mode or change from Memory Only
Reception mode.
When the four-digit numeric password is registered, the password input is
required upon outputting documents or change from Memory Only Reception
mode.
Operation: The programming operations are described in Fig. 4-3-1 and Fig. 4-3-23.