Filter
Top Products
180 Other Settings
Chapter 9 System Settings
The status area shows a list of DCU input ports with
their current signal assignments.
2
Using any of the following methods, select an input
port for the assignment. You can choose either a port
with no current assignment (No Assign), or a port with
an assignment. Then select the GPI input to assign.
• Press directry on the list in the status area.
• Use the arrow buttons to scroll the reverse video
cursor.
• Turn the knobs.
a) For the MKS-2700, set in the range 1 to 34.
3
Press [GPI Set].
To clear GPI input assignments
Select an input port, as in step 2 of the above procedure,
then press [Clear].
Setting DCU GPI inputs
1
From the top menu, select Setup/Diag >GPI >DCU
GPI In.
The DCU GPI Input menu appears.
The status area shows the GPI input ports and the
trigger type and action settings of the signals input to
each port.
2
Using any of the following methods, select the GPI
input to set.
• Press directry on the list in the status area.
• Use the arrow buttons to scroll the reverse video
cursor.
• Turn the knob.
To change trigger type settings
Press [Trigger Type] to display a popup window, then
select the trigger type.
(falling edge): Trigger is applied on the falling
edge of an input pulse.
(rising edge): Trigger is applied on the rising edge
of an input pulse.
(both edges): Trigger is applied on both falling and
rising edges of an input pulse.
Level: Trigger is applied when the input changes to low or
high.
Disable (disabled): Ignore input pulses.
To change action settings
When the trigger type is other than [Level] or [Disable],
you can press [Action] to display a popup window and
select from the actions in the following table.
Note
If you change the trigger type setting from any of falling
edge, rising edge, and both edges to [Level], or vice versa,
the action is automatically changed to [No Action].
For details of the action when the trigger type is set to
[Level], see “Setting the action when the trigger type is
[Level]” (page 179).
Knob Description Setting values
1 (Port) DCU input port number
selection
1 to 102
a)
2 (GPI) GPI input number
selection
1 to 50
Knob Description Setting values
1 (GPI) GPI input number
selection
1 to 50
Operating button Status area display
M/E Auto Trans M/E AT
M/E Cut M/E Cut
P/P Auto Trans
a)
P/P AT