Filter
Top Products
Chapter 5 Basic Operations
70 Preparing Transitions
To set transition rates with the Flexi Pad control block
1
In the Flexi Pad control block, press the [TRANS RATE] mode selection
button, lighting it.
The Flexi Pad control block enters transition rate input mode.
2
Select the target of the setting with the delegation selection buttons.
• Press [M/E] to set for the M/E bank.
• Press [PP/ALL] to set for the PGM/PST bank (when using the 1.5M/E
panel).
3
Enter the transition rate as a number of frames. (The setting range is 0 to
999.)
4
Press the [ENTR] button.
This confirms the input. The transition rate appears beneath the fader lever
in the transition control block.
To set transition rates from menus
1
From the top menu, select Misc >Transition.
The Transition menu appears.
1
3,42
1
3,42
1 M/E panel
1.5 M/E panel
Transition rate display
Transition rate display