Filter
Top Products
184 Other Settings
Chapter 9 System Settings
To couple external boxes
For the external boxes that you want to connect, set the
same destinations and levels in step 6.
By coupling a number of external boxes, you can increase
the number of inputs.
Example:
External box 1: set to 8 × 1 size
External box 2: set to 32 × 1 size
By coupling these two external boxes, you obtain 40
inputs (=8+32).
Making tally group settings
With the S-Bus protocol, tally control is possible for
groups 1 to 8, but in this system you can use either groups
1 to 4 or groups 5 to 8. You can select whether or not to
transfer tally information over the S-Bus, and select the
type of grouping.
1
From the top menu, select Setup/Diag >System Tally
>Group Tally.
The Group Tally menu appears.
2
Press [Tally Group].
A popup window appears.
3
Select the groups to use.
Group 1-4: Use groups 1 to 4.
Group 5-8: Use groups 5 to 8.
4
Press [S-Bus Tally] to select whether or not to transfer
tally information over the S-Bus.
Each press toggles between On (transfer) and Off (do
not transfer).
5
Press [Tally Gp Sel].
A popup window appears.
6
Select the type of grouping.
Separate: Do not group. Transfer tally information
separately for each of the eight tallies.
4 Groups Connect: Group the data areas of Group 1
to 4 (or Group 5 to 8) and transfer as the tally
information of Group 1 (or Group 5).
2 Groups Connect: Group data areas in pairs Group
1/2 and Group 3/4 (or Group 5/6 and Group 7/8)
and transfer as the tally information of Group 1 (or
Group 5) and Group 3 (or Group 7).
Making tally generation settings
Use the following procedures to make tally generation
settings by setting destination, tally type, and input port
parameters, and to modify existing settings.
To make new tally generation settings
1
From the top menu, select Setup/Diag >System Tally
>Tally Enable.
The Tally Enable appears. The status area shows tally
setting information.
2
Press [New], turning it on, and turn the knobs to set the
following parameters.
a) The tally type display changes according to the tally group in use (R
is red tally, and G is green tally).
3
Press [Tally Enable].
A popup window appears.
4
Set the tally generation conditions.
Tally Input: Generate a tally when a tally input port is
active.
Knob Description Setting values
2 (Dest Add) Source/destination
address
1 to 1024
3 (Dest Lvl) Destination level 1 to 8
4 (Tally Type) Tally type
1 (R1) to 8(G4)
a)
Tally group Tally type
Group 1-4 1: R1, 2: G1, 3: R2, 4: G2, 5: R3, 6:
G3, 7: R4, 8: G4
Group 5-8 1: R5, 2: G5, 3: R6, 4: G6, 5: R7, 6:
G7, 7: R8, 8: G8