Filter
Top Products
Chapter 2 Names and Functions of Parts
23Control Panel Configuration
Macro Control Block
a PRE MCRO button
Use this button to set a macro attachment in pre macro
mode.
When you make settings in macro only mode, this button
is used together with the Macro Only Set button, assigned
to one of the buttons in the utility control block.
b POST MCRO button
Use this button to set a macro attachment in post macro
mode.
When you make settings in macro only mode, this button
is used together with the Macro Only Set button, assigned
to one of the buttons in the utility control block.
c ATTCH ENBL (attachment enable) button
When this button is on, macro attachments assigned to
buttons on the control panel are enabled.
Menu Control Block
a Top menu selection buttons
Select the menu shown in the menu display.
• TOP/SHUTDOWN (top menu/shutdown) button
• REG (register menu) button
• FILE (file menu) button
• SET UP (setup menu) button
• DIAG (diagnostics menu) button
b Knobs
Use to adjust parameters shown in the menus.
Power Indicators, “Memory Stick”
Slot, USB Connector
a Power A and B status indicators
Two power supplies (A and B) can be installed in the
control panel. When the control panel is powered on, the
indicators corresponding to the installed power supplies
light in green.
PRE
MCRO
POST
MCRO
ATTCH
ENBL
MACRO
1PRE MCRO button
2POST MCRO button
3ATTCH ENBL button
MENU
REG
FILE
DIAG
SET
UP
TOP/
SHUT
DOWN
1Top menu selection buttons
Menu display
2Knobs
A POWER B
1Power A and B status indicators
2“Memory Stick” status indicator
3“Memory Stick” slot
4USB connector