Filter
Top Products
Chapter 4 Basics of Video Switching
46 Basic Operations (1): Video Switching on the M/E Bank
Now, notice again how the buttons in the background A and B rows are lit.
With the transition complete, the 3rd button from the left in the A row is lit
in red, and the 2nd button from the left in the B row is lit in amber. This
means that the signal selections in the A and B rows have been exchanged.
In other words, the lion video is now selected in the A row, and the
landscape video is selected in the B row.
In this state, try moving the fader lever from the bottom to the top. The
transition takes place in the same direction as last time (from A bus video to
B bus video), but this time the lion is replaced by the landscape.
About auto transitions
An auto transition is executed if, in step 6, you press the [AUTO TRANS]
button in the transition execution control block instead of moving the fader
lever.
The time from the start to the end of the transition is called the “transition rate”
(unit: frames). The transition rate can be freely set in the range from 0 to 999
frames.
See “Setting Transition Rates” (page 69) for more information about how to
specify transition rates.
About cut transitions
A cut transition is executed if, in step 6, you press the [CUT] button in the
transition execution control block instead of moving the fader lever. In this case,
the transition type selected in step 4 (effect) and the effect pattern selected in
step 5 (0024) are ignored.