Setting Terminal Parameters 7
8 In the Properties dialog box, select the Settings tab, as shown in Figure 6.
9 Select VT100 in the Emulation dropdown menu.
10 Click OK.
Figure 6 Settings Tab
Setting the Terminal Parameters is described in the following sections:
■ Configuring Through Telnet
■ Configuring Through a Dial-up Modem
■ Configuring the User Interface
Configuring Through
Telnet
Before you can telnet to a Switch 8800 and configure it, you must:
1 Configure the IP address of a VLAN interface for the Switch 8800 through the
console port (using the ip address command in VLAN interface view)
2 Add the port (that connects to a terminal) to this VLAN (using the port command
in VLAN view)
3 Log in to the Switch 8800
Tasks for Configuring through Telnet are described in the following sections:
■ Connecting the PC to the Switch 8800
■ Connecting Two Switch 8800 Systems