3Com 3.01.01 Switch User Manual


 
80 CHAPTER 5: IP ROUTING PROTOCOL OPERATION
By default, RIP does not filter received and distributed routing information.
Displaying and Debugging RIP
After configuring RIP, execute the display command in all views to display the RIP
configuration, and to verify the effect of the configuration. Execute the
debugging command in user view to debug the RIP module. Execute the reset
command in RIP view to reset the system configuration parameters of RIP.
Example: Typical RIP
Configuration
As shown in Figure 4, the Switch C connects to the subnet 117.102.0.0 through
the Ethernet port. The Ethernet ports of Switch A and Switch B are connected to
the network 155.10.1.0 and 196.38.165.0. Switch C, Switch A, and Switch B are
connected by Ethernet 110.11.2.0. Correctly configure RIP to ensure that Switch
C, Switch A, and Switch B can interconnect.
Figure 4 RIP Configuration
The following configuration only shows the operations related to RIP. Before
performing the following configuration, verify that the Ethernet link layer works
normally.
1 Configure RIP on Switch A:
[Switch A]rip
[Switch A-rip]network 110.11.2.0
[Switch A-rip]network 155.10.1.0
2 Configure RIP on Switch B:
[Switch B]rip
[Switch B-rip]network 196.38.165.0
Table 22 Displaying and Debugging RIP
Operation Command
Display the current RIP state and configuration
information.
display rip
Enable the RIP debugging information debugging rip packets
Enable the debugging of RIP receiving packet. debugging rip receive
Enable the debugging of RIP sending packet. debugging rip send
Restore the default RIP settings reset
Network address:
155.10.1.0/24
Interface address:
155.10.1.1/24
Switch A
Interface address:
110.11.2.1/24
Ethernet
Switch C
Network address:
110.11.2.2/24
Switch B
Network address:
196.38.165.0/24
Interface address:
196.38.165.1/24
Interface address:
117.102.0.1/16
Network address:
117.102.0.0/16