3Com 3.01.01 Switch User Manual


 
Managing the MAC Address Table 311
Execute the debugging command in user view to debug MAC address table
configuration.
Example: Configuring
MAC Address Table
Management
The user logs in to the switch through the console port to configure the address
table management. Set the address aging time to 500s and add a static address
00e0-fc35-dc71 to GigabitEthernet1/1/2 in vlan1.
Figure 2 Typical Configuration of Address Table Management
1 Enter the system view of the switch.
<SW8800>system-view
2 Add a MAC address (specify the native VLAN, port and state).
[SW8800]mac-address static 00e0-fc35-dc71 interface
GigabitEthernet1/1/2 vlan 1
3 Set the address aging time to 500s.
[SW8800]mac-address timer 500
4 Display the MAC address configurations in all views.
[SW8800]display mac-address interface Ethernet 1/1/2
MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)
00-e0-fc-35-dc-71 1 Static Ethernet1/1/2 NOAGED
Table 20 Displaying and Debugging MAC Address Table
Operation Command
Display the information in the address table display mac-address [ static | dynamic ] [[
interface { interface-name | interface-type
interface-num } ] [ vlan vlan-id ] ]
Display the aging time of dynamic address
table entries
display mac-address aging-time
Display the dynamic MAC address learning
capability of the system and ports
display mac-address learning [
interface-type interface-num | interface-name
]
Enable the address table management
debugging
debugging mac-address
Disable the address table management
debugging
undo debugging mac-address
Console port
Network port
Internet
Switch