3Com 3.01.01 Switch User Manual


 
14 CHAPTER 1: SYSTEM ACCESS
By default, terminal service is enabled on all the user interfaces.
Note the following points:
For the sake of security, the undo shell command can only be used on the user
interfaces other than the AUX user interface.
You cannot use this command on the user interface through which you log in.
You must confirm your privilege before using the undo shell command in any
legal user interface.
Configuring idle-timeout By default, idle-timeout is enabled and set to 10
minutes on all the user interfaces. The idle-timeout command is described in
Table 5.
Locking the User Interface The lock command locks the current user interface
and prompts the user to enter a password. This makes it impossible for others to
operate in the interface after the user leaves. The lock command is described in
Table 6.
Setting the Screen Length If a command displays more than one screen of
information, you can use the screen length command to determine how many
lines are displayed on a screen so that information can be separated in different
screens and you can view it more conveniently. The screen-length command is
described in
Table 7.
By default, the terminal screen length is 24 lines.
Setting the History-Command Buffer Size
Table 8 describes the history-command max-size command.
By default, the size of the history-command max-size command buffer is 10.
Table 5 Idle Timeout
Operation Command
Configure idle-timeout idle-timeout minutes [ seconds ]
(idle-timeout 0 means disabling
idle-timeout.)
Restore the default idle-timeout undo idle-timeout
Table 6 Lock User Interface
Operation Command
Lock user interface lock
Table 7 Setting Screen Length
Operation Command
Set the screen length screen-length screen-length (screen-length
0 indicates to disable screen display separation
function.)
Restore the default screen length undo screen-length
Table 8 Set the History Command Buffer Size
Operation Command
Set the history command buffer size history-command max-size value