3Com 3.01.01 Switch User Manual


 
234 CHAPTER 7: QOS/ACL OPERATION
[SW8800-acl-basic-2000]rule 0 permit source 1.0.0.1 0 time-range
3com
3 Modify the next hop for the packets from PC1.
Define the next hop for the packets from PC1 as 2.0.0.1.
[SW8800-GigabitEthernet7/1/1]traffic-redirect inbound ip-group 2000
rule 0 next-hop 2.0.0.1
Queue Scheduling
Configuration Example
Modify the correspondence between 802.1p priority levels and local priority levels
to change the mapping between 802.1p priority levels and queues so that packets
are put into outbound queues according to the new mapping. Use WRR algorithm
for the queues 0 to 5 at the port GE7/1/1. Set the queues 0, 1 and 2 into WRR
queue 1, with weight respectively as 20, 20 and 30; set the queues 3, 4 and 5 into
WRR queue 2, with weight respectively as 20, 20 and 40. The queues 6 and 7 use
the SP algorithm. See
Queue Scheduling for the default mapping.
Figure 13 Networking for QoS configuration
1 Re-specify the mapping between 802.1p priority and local precedence.
[SW8800]qos cos-local-precedence-map 7 6 5 4 3 2 1 0
2 Use the WRR algorithm for the queues 0 to 5. Set the queues 0, 1 and 2 into WRR
queue 1, with weight respectively as 20, 20 and 30; set the queues 3, 4 and 5 into
WRR queue 2, with weight respectively as 20, 20 and 40. Use SP algorithm for the
queues 6 and 7.
[SW8800-GigabitEthernet7/1/1]queue-scheduler wrr group1 0 20 1 20 2
30 group2 3 20 4 20 5 40
[SW8800]display qos-interface GigabitEthernet7/1/1 queue-scheduler
Table 28 802.1p Priority -> Local Precedence Mapping Table
802.1p priority Local precedence
0 7
1 6
2 5
3 4
4 3
5 2
6 1
7 0
GE7/1/8
GE7/1/1
GE7/1/2
VLAN2,
1.0.0.1/8
VLAN3,
2.0.0.1/8
PC1
PC2
GE7/1/8
GE7/1/1
GE7/1/2
VLAN2,
1.0.0.1/8
VLAN3,
2.0.0.1/8
PC1
PC2