Filter
Top Products
344 CHAPTER 11: SYSTEM MANAGEMENT
[SW88005]ntp-service refclock-master 1
3 After performing local synchronization, set SW88004 as a peer.
[SW88005]ntp-service unicast-peer 3.0.1.32
The above examples configure SW88004 and SW88005 as peers and configure
SW88005 as in active peer mode and SW88004 in passive peer mode. Since
SW88005 is at stratum 1 and SW88004 is at stratum 3, synchronize SW88004 by
SW88005.
After synchronization, SW88004 status is shown as follows:
[SW88004]display ntp-service status
clock status: synchronized
clock stratum: 8
reference clock ID: LOCAL(0)
nominal frequency: 100.0000 Hz
actual frequency: 100.0000 Hz
clock precision: 2^17
clock offset: 0.0000 ms
root delay: 0.00 ms
root dispersion: 10.94 ms
peer dispersion: 10.00 ms
reference time: 20:54:25.156 UTC Mar 7 2002(C0325201.2811A112)
By this time, SW88004 has been synchronized by SW88005 and it is at stratum 2,
or higher than SW88005 by 1.
Display the sessions of SW88004 and you will see SW88004 has been connected
with SW88005.
[SW88004]display ntp-service sessions
source reference stra reach poll now offset delay
disper
********************************************************************
****** [12345]127.127.1.0 LOCAL(0) 7 377 64 57
0.0 0.0 1.0
[5]1.0.1.11 0.0.0.0 16 0 64 - 0.0
0.0 0.0
[5]128.108.22.44 0.0.0.0 16 0 64 - 0.0
0.0 0.0