Filter
Top Products
326 CHAPTER 11: SYSTEM MANAGEMENT
Perform the following configuration in system view.
The authentication parameter specifies that the packet is authenticated without
encryption. This parameter is supported only in SNMP V3.
The privacy parameter specifies that the packet is authenticated and encrypted.
This parameter is supported only in SNMP V3.
Setting the Source Address of the Trap
Use the following commands to set or remove the source address of the trap.
Perform the following configuration in system view.
Adding and Deleting a User to or from an SNMP Group
Use the following commands to add or delete a user to or from an SNMP group.
Perform the following configuration in system view.
Table 50 Setting and Deleting an SNMP Group
Operation Command
Setting an SNMP group snmp-agent group group-name { v1 | v2c } [
read-view read-view ] [ write-view
write-view ] [ notify-view notify-view ] [ acl
acl-list ]
snmp-agent group group-name v3 [
authentication | privacy ] [ read-view
read-view ] [ write-view write-view ] [
notify-view notify-view ] [ acl acl-list ]
Deleting an SNMP group undo snmp-agent group group-name { v1 |
v2c }
undo snmp-agent group group-name v3 [
authentication | privacy ]
Table 51 Setting the Source Address of the Trap
Operation Command
Set the Source Address of Trap snmp-agent trap source interface-name
interface-num
Remove the source address of trap undo snmp-agent trap source
Table 52 Adding and Deleting a User to or from an SNMP Group
Operation Command
Add a user to an SNMP group snmp-agent usm-user { v1 | v2c } username
groupname [ acl acl-list ]
snmp-agent usm-user v3 username
groupname [ authentication-mod { md5 |
sha } auth_password [ privacy-mod { des56
priv_password } ] ] acl acl-list
Delete a user from an SNMP group undo snmp-agent usm-user { v1 | v2c }
username groupname
undo snmp-agent usm-user v3 username
groupname { local | engineid engine-id }