3Com 3.01.01 Switch User Manual


 
314 CHAPTER 11: SYSTEM MANAGEMENT
Testing Tools for Network Connection
Logging Function
Configuring System
Basics
This section describes the following basic system configuration tasks:
Setting the System Name
Setting the System Clock
Setting the Time Zone
Setting Daylight Saving Time
Setting the System Name
Perform the following commands in system view.
Setting the System Clock
Perform the following command in user view.
Setting the Time Zone
You can configure the name of the local time zone, and the time difference
between the local time and the standard Universal Time Coordinated (UTC).
Perform the following commands in user view.
By default, the UTC time zone is set.
Setting Daylight Saving Time
Use these commands to configure the start and end time of daylight saving time.
Perform this command in user view.
Table 27 Setting the System Name
Operation Command
Set the switch name sysname sysname
Restore the switch name to the default name undo sysname
Table 28 Setting the System Clock
Operation Command
Set the system clock clock datetime HH:MM:SS YYYY/MM/DD
Table 29 Setting the Time Zone
Operation Command
Set the local time clock timezone zone_name { add | minus }
HH:MM:SS
Restore to the default UTC time zone undo clock timezone
Table 30 Setting Daylight Saving Time
Operation Command
Set the name and range of daylight saving
time
clock summer-time zone_name { one-off |
repeating } start-time start-date end-time
end-date offset-time
Remove the setting of the summer time undo clock summer-time