![](http://pdfasset.owneriq.net/5/04/5049cd2b-4349-4b23-98d3-cec81535b62b/5049cd2b-4349-4b23-98d3-cec81535b62b-bg37.png)
Configuring GARP/GVRP 47
Figure 2 GVRP Configuration Example
Configure Switch A:
1 Set GigabitEthernet3/1/1 as a trunk port and allow all the VLANs to pass through.
[SW8800]interface GigabitEthernet3/1/1
[SW8800-GigabitEthernet3/1/1]port link-type trunk
[SW8800-GigabitEthernet3/1/1]port trunk permit vlan all
2 Enable GVRP on the trunk port.
[SW8800-GigabitEthernet3/1/1]gvrp
Configure Switch B:
1 Enable GVRP globally.
[SW8800]gvrp
2 Set Gigabit Ethernet4/1/1 as a trunk port and allow all the VLANs to pass
through.
[SW8800]interface GigabitEthernet4/1/1
[SW8800-GigabitEthernet4/1/1]port link-type trunk
[SW8800-GigabitEthernet4/1/1]port trunk permit vlan all
3 Enable GVRP on the trunk port.
[SW8800-GigabitEthernet4/1/1]gvrp
Switch A
E3/1/1
Switch B
E4/1/1