3Com 3.01.01 Switch User Manual


 
190 CHAPTER 6: MULTICAST PROTOCOL
Configuring the Filtering of Multicast Source/Group
You can set to filter the source (and group) address of multicast data packets via
this command. When this feature is configured, the router filters not only
multicast data, but the multicast data encapsulated in the registration packets.
Perform the following configuration in the PIM view.
If resource address filtering is configured, as well as basic ACLs, then the router
filters the resource addresses of all multicast data packets received. Those not
matched will be discarded.
If resource address filtering is configured, as well as advanced ACLs, then the
router filters the resource and group addresses of all multicast data packets
received. Those not matched will be discarded.
Configuring the Filtering of PIM Neighbors
You can set to filter the PIM neighbors on the current interface via the following
configuration.
Perform the following configuration in the PIM view.
By default, no filtering rules are set.
Only the routers that match the filtering rule in the ACL can serve as a PIM
neighbor of the current interface.
Configuring the Maximum Number of PIM Neighbor on an Interface
You can limit the PIM neighbors on an interface. No neighbor can be added any
more when the limit is reached.
Perform the following configuration in the PIM view.
By default, the PIM neighbors on the interface are limited to 128.
Table 28 Configuring the Filtering of Multicast Source/Group
Operation Command
Configure the filtering of multicast
source/group
source-policy acl-number
Remove the configuration of filtering undo source-policy
Table 29 Configuring the Filtering of PIM Neighbors
Operation Command
Configure filtering of PIM neighbor pim neighbor-policy acl-number
Remove the configuration of filtering undo pim neighbor-policy
Table 30 Configure the Maximum Number of PIM Neighbor on an Interface
Operation Command
Configure the maximum number of PIM
neighbor on an interface
pim neighbor-limit limit
Restore the limit of PIN neighbor to the
default value
pim neighbor-limit