3Com 3.01.01 Switch User Manual


 
Configuring Link Aggregation 37
Perform the following configuration in system view.
Adding or Deleting Ethernet Ports to or from an Aggregation Group
You can use the following commnad to add or delete ports into/from a manual
aggregation group.
Perform the following configuration in corresponding view.
Note that you must delete the aggregation group, instead of the port, if the
manual aggregation group contains only one port.
Setting or Deleting an Aggregation Group Descriptor
Perform the following configuration in system view.
By default, an aggregation group has no descriptor.
Displaying and Debugging Link Aggregation
After you have completed your configuration, execute the display command in
any view to display the link aggregation configuration, and to verify the effect of
the configuration.
Table 16 Create or Delete an Aggregation Group
Operation Command
Create an aggregation group link-aggregation group agg-id mode {
manual }
Delete an aggregation group undo link-aggregation group agg-id
Table 17 Adding or Deleting an Ethernet Port to or from an Aggregation Group
Operation Command
Add an Ethernet port into the aggregation
group (Ethernet port view)
port link-aggregation group agg-id
Delete an Ethernet port from the aggregation
port (Ethernet port view)
undo port link-aggregation group
Aggregate Ethernet ports (System view) link-aggregation interface_name1 to
interface_name2 [ both ]
Table 18 Setting or Deleting an Aggregation Group Descriptor
Operation Command
Set aggregation group descriptor link-aggregation group agg-id description
alname
Delete aggregation group descriptor undo link-aggregation group agg-id
description
Table 19 Display and Debug Link Aggregation
Operation Command
Display summary information of all
aggregation groups
display link-aggregation summary
Display detailed information of a specific
aggregation group
display link-aggregation verbose agg-id