328 CHAPTER 11: SYSTEM MANAGEMENT
If a user disables an NMP Agent, it is enabled whatever snmp-agent command is
configured.
Displaying and Debugging SNMP
Execute the display command to view the SNMP configuration and to verify the
effect of the configuration. Execute the debugging command in user view to
debug the SNMP configuration.
Example: SNMP
Configuration
The IP address of NMS is 129.102.149.23 and the IP address of the VLAN interface
on the switch is 129.102.0.1.
Perform the following configurations on the switch:
■ Set the community name and access authority
■ Set the administrator ID, contact and switch location
■ Enable the switch to send a trap packet.
Table 57 Displaying and Debugging SNMP
Operation Command
Display the statistics information about SNMP
packets
display snmp-agent statisitcs
Display the engine ID of the active device display snmp-agent { local-engineid |
remote-engineid }
Display the group name, the security mode,
the states for all types of views, and the
storage mode of each group of the switch.
display snmp-agent group
Display the names of all users in the group
user table
display snmp-agent usm-user [ { local | {
engineid engineid } } | username groupname ]
Display the current community name display snmp-agent community [ read |
write ]
Display the current MIB view display snmp-agent mib-view [ exclude |
include | viewname mib-view ]
Display the contact character string of the
system
display snmp-agent sys-info contact
Display the location character string of the
system
display snmp-agent sys-info location
Display the version character string of the
system
display snmp-agent sys-info version