Filter
Top Products
178 APPENDIX A: UPGRADING VCX SERVER SOFTWARE FROM V7.0 TO V7.1
Enter y to continue. The script executes.
During script execution, messages appear describing the replication
setup. Messages also appear stating that firewall setup should allow
communication between the primary VCX server and the secondary
VCX server. These messages are a reminder—firewall setup was
performed during VCX software installation.
f The
Have you executed the ABOVE mentioned VCX-FIREWALL
steps? [y/n]:
prompt appears.
Enter
y to continue. The script executes.
When the replication is complete, Multi-Master Replication Status is
reported as NORMAL. Do not continue to the next step until the
replication is complete. Note that replication can take approximately
20 minutes to complete.
g You can check replication status by entering the following command:
./checkReplication
3 When the replication is complete and status is reported as NORMAL,
enter the following command to exit the cworks account and return to
the root account:
exit
4 Start the Authentication and Directory service on the primary VCX server
and the secondary VCX server by entering the following commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata start
5 Start the Tomcat process on the primary VCX server and the secondary
VCX server by entering the following command:
./S70tomcat start
Upgrading a
Single-Site System
With Four Servers
Single-site VCX systems can have either two servers or four servers.
■ In a two-server configuration, each server runs IP Telephony server
software and IP Messaging server software.
■ In a four-server configuration, one pair of servers runs IP Telephony
server software; the second pair of servers runs IP Messaging server
software.