Filter
Top Products
Upgrading a Single-Site System With Two Servers 223
The system displays several status messages. The last two messages are:
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.1.yc is now available -------------------
2 Switch to the new software version by entering the following command:
vcx-switchversion 7.1.yc
The system displays several status messages and then reboots. After the
the reboot process has been completed, the system starts VCX 7.1.y
services.
3 After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.yc). If the link does not point to the new version, wait a few
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.1.yc
4 Stop the Authentication and Directory service by entering the following
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
Set Up Database
Replication
Follow the steps in this section to set up database replication.
1 Stop the Tomcat process, first on the primary VCX server and then on the
secondary VCX server by entering these commands:
cd /opt/3com/VCX/scripts/rc3.d
./S70tomcat stop
2 Set up replication on the primary VCX server by entering these
commands:
cd /opt/3com/VCX/vcxdata/bin
su cworks
./setupReplication
The replication setup script starts. Follow these steps:
a The
Enter the VCX Site Identification i.e. Site Id prompt
appears.