Filter
Top Products
270 APPENDIX C: UPGRADING VCX SERVER SOFTWARE FROM V6.0 TO V7.0
The system displays several status messages and then reboots. After the
the reboot process has been completed, the system starts VCX 7.0.x IP
Telephony services.
5 After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.0.xc).
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.0.xc
6 Stop the Authentication and Directory service by entering the following
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata stop
Upgrading the
Secondary IP
Messaging Server
Follow the steps in this section to upgrade the secondary IP Messaging
server.
1 To start the upgrade process, enter these commands on the secondary IP
Messaging server:
cd /opt/installtemp
tar xvf vcx-ipmsg-7.0.xc.tar
cd upgrade-7.0.xc
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are:
------------------- Installation Completed Successfully -------------------
------------------- VCX version 7.0.xc is now available -------------------
2 Obtain a license key for the server. See Obtaining a License Key File.
3 Install the license key. See Installing a License Key File
.
4 Switch to the new software version by entering the following command:
vcx-switchversion 7.0.xc