Filter
Top Products
Upgrading a Multi-Site VCX System with Branch Offices 241
Telephony and Messaging Server for more information. In this
example, there is one Master site, Region 2.
c The
Enter the MASTER DEFINITION SITE IP Address [IP
address]
prompt appears.
Enter the IP address of the Master Definition site. This is the IP address
of the eth0 interface on this server (the Authentication and Directory
server in Region 1).
d The
Enter the MASTER SITE 1 IP Address [0.0.0.0] prompt
appears.
Enter the IP address of the Master Site. This is the IP address of the
eth0 interface on the Authentication and Directory server in Region 2.
If there are more than one Master Sites, this question repeats until the
number of master sites specified in step b is reached.
e The
Do you want to continue with the above settings? [n/y]:
prompt appears.
Enter
y to continue. The script executes.
When the replication is complete, Multi-Master Replication Status is
reported as NORMAL. Do not continue to the next step on this server
until the replication is complete. Note that replication can take
approximately 20 minutes to complete.
f You can check the replication by entering the following command:
./checkReplication
6 Set up database replication on Region 2 by entering the following
commands (you should still be logged in to the Authentication and
Directory server as cworks):
cd /opt/3com/VCX/vcxdata/bin
./setupReplication
The replication setup script starts. Follow these steps:
a The
Enter the VCX Site Identification i.e. Site Id prompt
appears.
Enter site ID configured for Region 2.
b The
Enter the Number of MASTER SITEs other than the MASTER
DEFINITION SITE
: prompt appears.
Enter the number of Master sites. To determine the number of Master
Sites associated with this office, use the listVcxdata command. See
Manually Configuring Replication for an IP Telephony Server or IP