Filter
Top Products
232 APPENDIX B: UPGRADING VCX SERVER SOFTWARE FROM V7.1.X TO V7.1.Y
secondary IP Telephony server. These messages are a
reminder—firewall setup was performed during VCX software
installation.
f The
Have you executed the ABOVE mentioned VCX-FIREWALL
steps? [y/n]:
prompt appears.
Enter
y to continue. The script executes.
When the replication is complete, Multi-Master Replication Status is
reported as NORMAL. Do not continue to the next step until the
replication is complete. Note that replication can take approximately
20 minutes to complete.
g You can check the replication by entering the following command:
./checkReplication
3 When the replication is complete, enter the following command to exit
the cworks account and return to the root account:
exit
4 Start the Authentication and Directory service on the primary IP Telephony
server and the secondary IP Telephony server by entering the following
commands:
cd /opt/3com/VCX/scripts/rc3.d
./S20vcxdata start
5 Start the Tomcat process on the primary IP Telephony server and the
secondary IP Telephony server by entering the following command:
./S70tomcat start
Upgrading a
Multi-Site System
With No Branch
Offices
Some VCX multi-site systems have regional offices but no branch offices.
Each regional office contains a primary VCX server and a secondary VCX
server. These servers perform call processing and IP Messaging tasks. One
of the regional offices also contains a Call Records server which gathers
call records from each of the regional offices.
■ To upgrade the primary VCX server and the secondary VCX server,
follow the instructions in Upgrading a Single-Site System With Two
Servers earlier in this appendix.
■ To upgrade the Call Records server, see the following section,
Upgrading the Call Records Server
.