Filter
Top Products
196 APPENDIX A: UPGRADING VCX SERVER SOFTWARE FROM V7.0 TO V7.1
b The Enter the Number of MASTER SITEs other than the MASTER
DEFINITION SITE
: prompt appears.
Enter the number of Master sites. To determine the number of Master
sites associated with this server, use the listVcxdata command. See
Manually Configuring Replication for an IP Telephony Server or IP
Telephony and Messaging Server for more information. In this
example, there is one Master site, Region 1.
c The
Enter the MASTER DEFINITION SITE IP Address [IP
address]
prompt appears.
Enter the IP address of the Master Definition site. This is the IP address
of the eth0 interface on this server (the Authentication and Directory
server in Region 2).
d The
Enter the MASTER SITE 1 IP Address [0.0.0.0] prompt
appears.
Enter the IP address of the Master Site. This is the IP address of the
eth0 interface on the Authentication and Directory server in Region 1.
If there are more than one Master Sites, this question repeats until the
number of master sites specified in step b is reached.
e The
Do you want to continue with the above settings? [n/y]:
prompt appears.
Enter
y to continue. The script executes.
5 Enter the following command to exit the cworks account and return to
the root account:
exit
6 Obtain a copy of the vcx-dataserver-7.1.xc.tar software upgrade file
and place it in the
/opt/installtemp directory on the Authentication
and Directory server. The variable
x indicates the version of VCX software
(for example,
vcx-all-7.0.3c.tar) that will replace the current version.
The letter
c is always appended to the version number.
7 Enter these commands:
cd /opt/installtemp
tar xvf vcx-dataserver-7.1.xc.tar
cd upgrade-7.1.x
./install-upgrade
The system may prompt you to confirm that a new operating system
version will be installed and indicates which disk partition will be used
after the upgrade. If you see such a prompt, answer y.
The system displays several status messages. The last two messages are: