Filter
Top Products
Upgrading a Single-Site System With Four Servers 187
If you do not have a UPS installed and enter n (or press Enter); the
remaining UPS configuration prompts are not displayed.
If you do have a UPS installed and enter
y and see Configuring UPS
Monitoring for information on the subsequent UPS configuration
prompts.
4 After completing the UPS Monitoring prompts, the server reboots. When
the reboot process has been completed, the system starts VCX 7.1.x
services.
5 After the system has completed the restart process, verify that the
upgrade has occurred by entering this command:
ls -l /opt/3com/VCX
The symbolic link (VCX) should point to the new version of the VCX
software (7.1.xc). If the link does not point to the new version, wait a few
minutes and reenter the command. This could take several minutes and it
is important the link pointer is correct before proceeding.
Example Output
/opt/3com/VCX -> /opt/3com/VCX.7.1.xc
Set Up Database
Replication
Follow the steps in this section to set up database replication.
1 Stop the Tomcat process, first on the primary IP Telephony server and
then on the secondary IP Telephony server by entering these commands
(log in as root):
cd /opt/3com/VCX/scripts/rc3.d
./S70tomcat stop
2 Set up replication on the primary IP Telephony server by entering these
commands:
cd /opt/3com/VCX/vcxdata/bin
su cworks
./setupReplication
The replication setup script starts. Follow these steps:
a The
Enter the VCX Site Identification i.e. Site Id prompt
appears.
Enter site ID configured for this system. For single-site systems, the site
ID is identical for both the primary IP Telephony server and the
secondary IP Telephony server.