Filter
Top Products
327
Setting up the Printer as an ATPS Remote Printer
9 Select the SYS:\SYSTEM\AUTOEXEC.NCF file and press Enter.
A window appears, displaying the file’s contents.
10 Insert the following line after the
load afp
statement:
load atps
This command instructs the NetWare server to automatically load the ATPS
service at startup time.
11 Press Esc to exit the editor, then type
y
and press Enter to confirm the changes.
12 Press Esc three times to exit the Install utility.
13 At the system console prompt, type
load atps
and press Enter.
The service is loaded and immediately becomes available to network users. A
message appears confirming the load, and the console displays its prompt.
Modifying an existing ATPS configuration on a NetWare 3.x server
The procedure for modifying an existing ATPS configuration is similar to the
procedure for creating a new configuration. The primary difference is that
you are modifying an existing AUTOEXEC.NCF file instead of creating a
new one.
1 At the console prompt, type
load install
The Install utility starts and a list of Installation Options appears.
2 Select Product Options from the list and press Enter.
A list of product options appears. If the NLM is installed and operating
properly, a NW-MAC option will be available.
3 Select the NW-MAC option and press Enter.
A list of configuration files appears.
4 From the list, select the file SYS:\SYSTEM\ATPS.CFG and press Enter.
A prompt appears, asking if you want to create a new file.