Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
118
To remove the VLAN “v1”:
DGS-3324SRi:4#delete vlan v1
Command: delete vlan v1
Success.
DGS-3324SRi:4#
config vlan add
Purpose Used to add additional ports to a previously configured VLAN.
Syntax
config vlan <vlan_name 32> {[add [ tagged | untagged |
forbidden] <portlist> | advertisement [enable | disable]}
Description This command is used to add ports to the port list of a previously
configured VLAN. Additional ports may be specified as tagging,
untagging, or forbidden. The default is to assign the ports as
untagging.
Parameters
<vlan_name 32> − The name of the VLAN to add or delete ports
to.
add − Specifies which ports to add. The user may also specify if
the ports are:
tagged − Specifies the additional ports as tagged.
untagged − Specifies the additional ports as untagged.
forbidden − Specifies the additional ports as forbidden.
<portlist> − A range of ports to add to the VLAN. The port list is
specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end
of the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3
and switch 2, port 4 − in numerical order.
advertisement [enable | disable] − Enables or disables GVRP on
the specified VLAN.
Restrictions Only administrator-level users can issue this command.
Example usage:
To add 4 through 8 of module 2 as tagged ports to the VLAN v1:
DGS-3324SRi:4#config vlan v1 add tagged 2:4-2:8
Command: config vlan v1 add tagged 2:4-2:8
Success.
DGS-3324SRi:4#