Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
334
config ospf ipif
Parameters
<ipif_name 12> − The name of the IP interface.
area <area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
priority <value> − The priority used in the election of the
Designated Router (DR). A number between 0 and 255.
hello_interval <sec 1-65535> − Allows the specification of the
interval between the transmission of OSPF Hello packets, in
seconds. Between 1 and 65535 seconds can be specified. The
Hello Interval, Dead Interval, Authorization Type, and Authorization
Key should be the same for all routers on the same network.
dead_interval <sec 1-65535> − Allows the specification of the
length of time between the receipt of Hello packets from a neighbor
router before the selected area declares that router down. An
interval between 1 and 65535 seconds can be specified. The Dead
Interval must be evenly divisible by the Hello Interval.
metric <value 1-65535 > − The interface metric (1 to 65535).
Entering a 0 will allow automatic calculation of the metric.
authentication – Enter the type of authentication preferred. The
user may choose between:
• none – Choosing this parameter will require no
authentication.
• simple <password 8> − Choosing this parameter will set a
simple authentication which includes a case-sensitive
password of no more than 8 characters.
• md5 <key_id 1-255> − Choosing this parameter will set
authentication based on md5 encryption. A previously
configured MD5 key ID (1 to 255) is required.
metric <value 1-65535> − This field allows the entry of a number
between 1 and 65,535 that is representative of the OSPF cost of
reaching the selected OSPF interface. The default metric is 1.
state [enable | disable] – Used to enable or disable this function.
Restrictions Only administrator-level users can issue this command.
Usage Example
To configure OSPF interface settings:
DGS-3324SRi:4#config ospf ipif System priority 2 hello_interval 15
metric 2 state enable
Command: config ospf ipif System priority 2 hello_interval 15
metric 2 state enable
Success.
DGS-3324SRi:4#