Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
150
Example Usage:
To disable MAC notification without changing basic configuration:
DGS-3324SRi:4#disable mac_notification
Command: disable mac_notification
Success.
DGS-3324SRi:4#
config mac_notification
Purpose Used to configure MAC address notification.
Syntax
config mac_notification {interval <int 1-2147483647> | historysize
<int 1-500>
Description MAC address notification is used to monitor MAC addresses learned
and entered into the FDB.
Parameters interval <int 1-2147483647> - The time in seconds between
notifications. The user may choose an interval between 1 and
2,147,483,647 seconds.
historysize <int 1-500> - The maximum number of entries listed in the
history log used for notification.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch’s MAC address table notification global settings:
DGS-3324SRi:4#config mac_notification interval 1 historysize 500
Command: config mac_notification interval 1 historysize 500
Success.
DGS-3324SRi:4#
config mac_notification ports
Purpose Used to configure MAC address notification status settings.
Syntax
config mac_notification ports [<portlist> | all] [enable | disable]
Description MAC address notification is used to monitor MAC addresses learned
and entered into the FDB.
Parameters <portlist> Specify a port or range of ports to be configured. The port list
is specified by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also separated by
a colon) are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1, port
3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4 − in numerical
order.
all – Entering this command will set all ports on the system.