Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
152
show mac_notification ports
Purpose Used to display the Switch’s MAC address table notification status
settings.
Syntax
show mac_notification ports <portlist>
Description This command is used to display the Switch’s MAC address table
notification status settings.
Parameters <portlist> - Specify a port or group of ports to be viewed. The port list
is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order.
Entering this command without the parameter will display the MAC
notification table for all ports.
Restrictions None
Example usage:
To display all port’s MAC address table notification status settings:
DGS-3324SRi:4#show mac_notification ports
Command: show mac_notification ports
Port # MAC Address Table Notification State
------ ------------------------------------
1:1 Disabled
1:2 Disabled
1:3 Disabled
1:4 Disabled
1:5 Disabled
1:6 Disabled
1:7 Disabled
1:8 Disabled
1:9 Disabled
1:10 Disabled
1:11 Disabled
1:12 Disabled
1:13 Disabled
1:14 Disabled
1:15 Disabled
1:16 Disabled
1:17 Disabled
1:18 Disabled
1:19 Disabled
1:20 Disabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh