Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
260
config dst
Description DST can be enabled and configured using this command. When
enabled this will adjust the system clock to comply with any DST
requirement. DST adjustment effects system time for both manually
configured time and time set using SNTP service.
Parameters disable - Disable the DST seasonal time adjustment for the Switch.
repeating - Using repeating mode will enable DST seasonal time
adjustment. Repeating mode requires that the DST beginning and
ending date be specified using a formula. For example, specify to
begin DST on Saturday during the second week of April and end DST
on Sunday during the last week of October.
annual - Using annual mode will enable DST seasonal time
adjustment. Annual mode requires that the DST beginning and ending
date be specified concisely. For example, specify to begin DST on
April 3 and end DST on October 14.
s_week - Configure the week of the month in which DST begins.
• <start_week 1-4,last> - The number of the week during the
month in which DST begins where 1 is the first week, 2 is the
second week and so on, last is the last week of the month.
e_week - Configure the week of the month in which DST ends.
• <end_week 1-4,last> - The number of the week during the
month in which DST ends where 1 is the first week, 2 is the
second week and so on, last is the last week of the month.
s_day – Configure the day of the week in which DST begins.
• <start_day sun-sat> - The day of the week in which DST begins
expressed using a three character abbreviation (sun, mon, tue,
wed, thu, fri, sat).
e_day - Configure the day of the week in which DST ends.
• <end_day sun-sat> - The day of the week in which DST ends
expressed using a three character abbreviation (sun, mon, tue,
wed, thu, fri, sat).
s_mth - Configure the month in which DST begins.
• <start_mth 1-12> - The month to begin DST expressed as a
number.
e_mth - Configure the month in which DST ends.
• <end_mth 1-12> - The month to end DST expressed as a
number.
s_time – Configure the time of day to begin DST.
• <start_time hh:mm> - Time is expressed using a 24-hour clock,
in hours and minutes.
e_time - Configure the time of day to end DST.
• <end_time hh:mm> - Time is expressed using a 24-hour clock,
in hours and minutes.
s_date - Configure the specific date (day of the month) to begin DST.
• <start_date 1-31> - The start date is expressed numerically.
e_date - Configure the specific date (day of the month) to begin DST.
• <end_date 1-31> - The end date is expressed numerically.
offset [30 | 60 | 90 | 120] - Indicates number of minutes to add or to