Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
247
show sim
Purpose Used to view the current information regarding the SIM group on the
Switch.
Syntax
show sim {[candidates {<candidate_id 1-100>} | members
{<member_id 1-32>} | group {commander_mac <macaddr>}
neighbor]}
Description This command will display the current information regarding the SIM group
on the Switch, including the following:
SIM Version - Displays the current Single IP Management version on the
Switch.
Firmware Version - Displays the current Firmware version on the Switch.
Device Name - Displays the user-defined device name on the Switch.
MAC Address - Displays the MAC Address of the Switch.
Capabilities – Displays the type of switch, be it Layer 2 (L2) or Layer 3 (L3).
Platform – Switch Description including name and model number.
SIM State – Displays the current Single IP Management State of the
Switch, whether it be enabled or disabled.
Role State – Displays the current role the Switch is taking, including
Commander, Member or Candidate. A stand-alone switch will always have
the candidate role.
Discovery Interval - Time in seconds the Switch will send discovery
packets out over the network.
Hold time – Displays the time in seconds the Switch will hold discovery
results before dropping it or utilizing it.
Parameters candidates <candidate_id 1-100> - Entering this parameter will display
information concerning candidates of the SIM group. To view a specific
candidate, include that candidate’s id number, listed from 1 to 100.
members <member_id 1-32> - Entering this parameter will display
information concerning members of the SIM group. To view a specific
member, include that member’s ID number, listed from 1 to 32.
group commander_mac <macaddr> - Entering this parameter will display
information concerning the SIM group of a commander device, identified by
its MAC address.
neighbor – Entering this parameter will display neighboring devices of the
Switch. A SIM neighbor is defined as a switch that is physically connected
to the Switch but is not part of the SIM group. This screen will produce the
following results:
• Port – Displays the physical port number of the commander switch
where the uplink to the neighbor switch is located.
• MAC Address – Displays the MAC Address of the neighbor switch.
• Role – Displays the role (CS, CaS, MS) of the neighbor switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To show the SIM information in detail: