Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
215
config access_profile profile_id (for Ethernet)
Syntax
config access_profile profile_id <value 1-8> [add access_id
[auto assign | <value 1-65535>] [ethernet {vlan <vlan_name 32>
| source_mac <macaddr 000000000000-ffffffffffff> |
destination_mac <macaddr 000000000000-ffffffffffff> | 802.1p
<value 0-7> | ethernet_type <hex 0x0-0xffff>} port <port> [permit
{priority <value 0-7> {replace_priority} | replace_dscp <value 0-
63> } | deny | mirror] delete <value 1-65535>]
Description This command is used to define the rules used by the Switch to
either filter or forward packets based on the Ethernet part of each
packet header.
Parameters profile_id <value 1-8> - Enter an integer between 1 and 8 that is
used to identify the access profile that will be configured with this
command. This value is assigned to the access profile when it is
created with the create access_profile command. The lower the
profile ID, the higher the priority the rule will be given.
add access_id <value 1-65535> - Adds an additional rule to the
above specified access profile. The value specifies the relative
priority of the additional rule. Up to 65535 different rules may be
configured for the Ethernet access profile.
auto_assign – Choose this parameter to configure the Switch
to automatically assign a numerical value (between 1 and
65535) for the rule being configured.
ethernet - Specifies that the Switch will look only into the layer 2 part
of each packet to determine if it is to be filtered or forwarded based
on one or more of the following:
• vlan <vlan_name 32> − Specifies that the access profile will
apply to only this previously created VLAN.
• source_mac <macaddr> − Specifies that the access profile will
apply to only packets with this source MAC address. MAC
address entries may be made in the following format:
000000000000-FFFFFFFFFFFF
• destination_mac <macaddr> − Specifies that the access profile
will apply to only packets with this destination MAC address.
MAC address entries may be made in the following format:
000000000000-FFFFFFFFFFFF
• 802.1p <value 0-7> − Specifies that the access profile will
apply only to packets with this 802.1p priority value.
• ethernet_type <hex 0x0-0xffff> − Specifies that the access
profile will apply only to packets with this hexadecimal 802.1Q
Ethernet type value in the packet header.
port <portlist> - The access profile for Ethernet may be defined for
each port on the Switch. Up to 65535 rules may be configured for
each port. The port list is specified by listing the switch ID number
and the port number on that switch, separated by a colon. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch
number 2, port 4.