Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
279
config route redistribute dst rip src
information is then exchanged among the various routers
according to the individual routers current routing protocol. The
Switch can redistribute routing information between the OSPF and
RIP routing protocols to all routers on the network that are running
OSPF or RIP. Routing information entered into the Static Routing
Table on the local switch is also redistributed.
Parameters
src {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2} −
Allows the selection of the protocol of the source device. The user
may choose between:
• all – Specifies both internal an external.
• internal – Specifies the internal protocol of the source device.
• external - Specifies the external protocol of the source
device.
• type_1 - Calculates the metric (for RIP to OSPF) by adding
the destination’s interface cost to the metric entered in the
Metric field.
• type_2 - Uses the metric entered in the Metric field without
change. This field applies only when the destination field is
OSPF.
• inter+e1 – Specifies the internal protocol AND type 1 of the
external protocol.
• inter+e2 – Specifies the internal protocol AND type 2 of the
external protocol.
metric <value> − Allows the entry of an OSPF interface cost. This
is analogous to a Hop Count in the RIP routing protocol.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure route redistributions:
DGS-3324SRi:4#config route redistribute dst ospf src rip type_1 metric 2
Command: config route redistribute dst ospf src rip type_1 metric 2
Success.
DGS-3324SRi:4#
delete route redistribute
Purpose Used to delete an existing route redistribute configuration on the
Switch.
Syntax
delete route redistribute {dst [rip | ospf] src [rip | static | local
| ospf]}
Description This command will delete the route redistribution settings on this
switch.