Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
300
Command Parameters
config pim crp {holdtime <value 0-255> | priority <value 0-255>
| wildcard_prefix_cnt [0 | 1]}
create pim static_rp group <network address> rp <ipaddr>
delete pim static_rp group <network address>
show pim static_rp
config pim rp_spt_threshold [<value 0-65535> | infinity]
config pim last_hop_spt_threshold [<value 0-65535> | infinity]
show pim rpset
show pim crp
config pim cbsr [ipif <ipif_name 12> {priority [-1 | <value 0-
255>]} | hash_masklen <value 0-32> |
bootstrap_period <value 1-255>]
show pim cbsr {ipif <ipif_name 12>}
show pim {ipif <ipif_name 12>}
show pim neighbor {ipif <ipif_name 12> | ipaddress
<network_address>}
show pim ipmroute
create pim
register_checksum_include_data
rp_address
<ipaddr>
delete pim
register_checksum_include_data
rp_address
<ipaddr>
show pim
register_checksum_include_data_rp_list
Each command is listed, in detail, in the following sections.
enable pim
Purpose Used to enable the PIM function on the Switch.
Syntax
enable pim
Description This command will enable PIM for the Switch. PIM settings must first
be configured for specific IP interfaces using the config pim
command.
Parameters None.
Restrictions Only administrator-level users can use this command.
Usage Example:
To enable PIM as previously configured on the Switch:
DGS-3324SRi:4#enable pim
Command: enable pim
Success.