Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
122
DGS-3324SRi:4#show vlan
Command: show vlan
VID : 1 VLAN Name : default
VLAN TYPE : 1QVLAN Protocol ID :
UserDefinedPid : Advertisement : Enabled
Encap :
Member ports : 1:1-1:24,2:1-2:24
Static ports : 1:1-1:24,2:1-2:24
Untagged ports : 1:1-1:24,2:1-2:24
Forbidden ports :
VID : 2 VLAN Name : v1
VLAN TYPE : PROTOCOL Protocol ID : ip
UserDefinedPid : Advertisement : Enabled
Encap :
Member ports : 1:1-1:24,2:1-2:24
Static ports : 1:24,2:24
Untagged ports :
Forbidden ports :
Total Entries : 2
DGS-3324SRi:4#
show gvrp
Purpose Used to display the GVRP status for a port list on the Switch.
Syntax
show gvrp {<portlist>}
Description This command displays the GVRP status for a port list on the
Switch.
Parameters
<portlist> − Specifies a range of ports for which the GVRP status
is to be displayed. The port list is specified by listing the lowest
switch number and the beginning port number on that switch,
separated by a colon. Then the highest switch number, and the
highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1,
port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all
of the ports between switch 1, port 3 and switch 2, port 4 − in
numerical order.
Restrictions None.
Example usage:
To display GVRP port status: