Filter
Top Products
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
128
config lacp_port
Purpose Used to configure settings for LACP compliant ports.
Syntax
config lacp_port <portlist> mode [active | passive]
Description This command is used to configure ports that have been previously
designated as LACP ports (see create link_aggregation).
Parameters
<portlist> − Specifies a range of ports to be configured. The port list is
specified by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also separated by a
colon) are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1, port
3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4 − in numerical
order.
mode – Select the mode to determine if LACP ports will initially send
LACP control frames.
active – Active LACP ports are capable of processing and
sending LACP control frames. This allows LACP compliant
devices to negotiate the aggregated link so the group may be
changed dynamically as needs require. In order to utilize the
ability to change an aggregated port group, that is, to add or
subtract ports from the group, at least one of the participating
devices must designate LACP ports as active. Both devices must
support LACP.
passive – LACP ports that are designated as passive cannot
initially send LACP control frames, unless the port receives LACP
frames. In order to allow the linked port group to negotiate
adjustments and make changes dynamically, at one end of the
connection must have “active” LACP ports (see above).
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure LACP port mode settings:
DGS-3324SRi:4#config lacp_port 1
:1-1:12 mode active
Command: config lacp_port 1
:1-1:12 mode active
Success.
DGS-3324SRi:4#